User Manual
User Manual
www.mininder.com 17 of 24
pico 4G
minifinder
Geofence AlarmGeofence Alarm
Geofence is a virtual limited area on the map. When a GPS device leaves a dened area, an alarm
notication, a ringing and an e-mail are sent according to the preferences in the setting.
1) Create a GeoFence
- Start by clicking on the Geofence tab (1) and click “Create” (2) as shown below.
- Then draw an area as a GeoFence on the map.
A) Press once on the map as starting point of the area.
B) Press again to place the second point of the area.
C) Press again to place the third point of the area.
D) Press again to place the forth point of the area.
E) Complete the area by pressing the starting point (point A).
F) Name the area and select which units to connect,
select “Enter” or “Leave” or both to create an alarm.
Then click “Create” to nish the process.
If you are not satised with the location of a point,
click “Back” to delete or hold to delete all and start over.