Switch User Manual

Operating th
e Smart 108/116 IP Switching System Locally
Using the OSD
64 | Smart 108/116 IP
Figure
Configuring Security Settings
The OSD comes with an advanced password security system that contains three
different security levels. Each security level has different
as follows:
 Administrator (Status A)
who can:

Set and modify all passwords and security profiles

Fully access any computer

Use all OSD functions
 Supervisor (Status S)
who can:

Fully access any computer

Access the following OSD
the Confirmation label.
 User (Status U) –
There are
Each User has a Profile set by the Administrator that defines the access level to
different computers.
There are
6.2.7 on page 68.
Activating Password Protection
By default,
OSD access is not password protected. Only the Administrator can
password-
protect the OSD or disable password protection.
To activate password protection:
1. In
the General settings window
2.
Press the Space bar to toggle between
The password dialog box appears.
3.
Type the Administrator’s password (default is “admin”).
4. Press Enter.
e Smart 108/116 IP Switching System Locally
Figure
54 – General Settings Window
Configuring Security Settings
The OSD comes with an advanced password security system that contains three
different security levels. Each security level has different
access rights to the system,
who can:
Set and modify all passwords and security profiles
Fully access any computer
Use all OSD functions
who can:
Fully access any computer
Access the following OSD
functions only –
F4 Scan, F5 Tune, and F6 Moving
the Confirmation label.
There are
six
different Users in the Smart 108/116 IP system.
Each User has a Profile set by the Administrator that defines the access level to
There are
three different access levels –
explained
Activating Password Protection
OSD access is not password protected. Only the Administrator can
protect the OSD or disable password protection.
To activate password protection:
the General settings window
(see Figure 54), navigate to the
Security
Press the Space bar to toggle between
Security On and Off.
The password dialog box appears.
Type the Administrator’s password (default is “admin”).
The OSD comes with an advanced password security system that contains three
access rights to the system,
F4 Scan, F5 Tune, and F6 Moving
different Users in the Smart 108/116 IP system.
Each User has a Profile set by the Administrator that defines the access level to
explained
in Section
OSD access is not password protected. Only the Administrator can
Security
line.