Switch User Manual

Conducting a Remote Session
Adjusting the Video
48 | Smart 108/116 IP
 To fine-tune the target s
erver video settings after auto adjustment
 To a
dapt to a noisy environment or a nonstandard VGA signal
 When in full-
screen DOS/CLI m
After adjusting the video
settings
adjusting the video settings
, as
To manually
adjust the video settings
1. On the toolbar, select
The
manual controls appear
Figure
37
2. In Brightness and
Contrast
the displayed image
, respectively
Click in the area of the sliders for fine
3. In the
Offset, Phase and Scale
erver video settings after auto adjustment
dapt to a noisy environment or a nonstandard VGA signal
screen DOS/CLI m
ode
settings
manually, you can always revert to
automatically
, as
explained in Section 4.7.2.
adjust the video settings
:
> Advanced.
manual controls appear
.
37
– Manual Video Adjustments Controls
Contrast
,
use the scales to adjust the brightness and contrast of
, respectively
. Move the sliders to change the displayed image.
Click in the area of the sliders for fine
-tuning.
Offset, Phase and Scale
section:
automatically
use the scales to adjust the brightness and contrast of
. Move the sliders to change the displayed image.