User guide

Operating the SmartRack 116 IP S
witching System Locally
Troubleshooting – Update Software
84 | SmartRack 116 IP
5. Click Start.
The SmartRack 116 IP
Switch Update flashes the firmware. On completion
firmware version number appears.
If the status of the device is busy
cannot be upgraded. To free the device
device resets
and the status is now free. Click
6.
Check that the updated version number is correct by pressing
Manually Updating the
RICC/ROCs
You can manually update the RICC/ROCs after starting the Update software.
To manually update the
RICC/ROCs
1.
Select one or more ROCs..
2. Press Options -
> Advanced
3.
Open the appropriate hex fi
4. Click Start.
The firmware updates.
6.3.9
Restoring Factory Settings
You can restore the OSD to the factory settings from the Update software.
All changes made (
such as
removed.
To restore the OSD factory settings:
1. Select
Options/Advanced/Set default
The OSD returns to the factory default settings.
You can also restore the OSD
6.4
Troubleshooting
This section
describes how to troubleshoot the following problems that may arise
when updating the
SmartRack 116 IP

Unit hangs or mouse malfunctions
 Break in communication
witching System Locally
Switch Update flashes the firmware. On completion
firmware version number appears.
If the status of the device is busy
- see the bottom of Figure 83-
the system
cannot be upgraded. To free the device
, choose
Options/Advanced/Reset
and the status is now free. Click
Start.
Check that the updated version number is correct by pressing
RICC/ROCs
You can manually update the RICC/ROCs after starting the Update software.
RICC/ROCs
:
Select one or more ROCs..
> Advanced
-> Manual Update.
Open the appropriate hex fi
le.
Restoring Factory Settings
You can restore the OSD to the factory settings from the Update software.
such as
passwords, access rights, and
names) will be
To restore the OSD factory settings:
Options/Advanced/Set default
.
The OSD returns to the factory default settings.
You can also restore the OSD
default settings from the OSD (F7) (
see
Troubleshooting
– Update Software
describes how to troubleshoot the following problems that may arise
SmartRack 116 IP
firmware:
Unit hangs or mouse malfunctions
Switch Update flashes the firmware. On completion
, the
the system
Options/Advanced/Reset
. The
.
You can manually update the RICC/ROCs after starting the Update software.
You can restore the OSD to the factory settings from the Update software.
names) will be
see
page 71)
describes how to troubleshoot the following problems that may arise