User guide

To enter Safe mode:
1. While powering up
SmartRack 116 IP
the back panel
of the unit
The device boots up i
n
2. Wait
until the unit finishes booting (
3. Determine
the IP address of the
whether or not
there is a DHCP server on the network. If there is, the DHCP ser
assigns an IP address to the
unit boots with the static IP address 192.168.2.155.
4.
Open Internet Explorer and type into the Address box:
(Do not start the address with
T
he Login page appears.
5. In User, type userna
m
(This usernam
e and pa
A menu appears.
5.2
Restoring Factory Defaults
You can restore all
SmartRack 116 IP
Troubleshooting
Restoring
SmartRack 116 IP
, press and hold down the
Go Local
of the unit
for three to four seconds.
n
Safe mode.
until the unit finishes booting (
one to two minutes).
the IP address of the
SmartRack 116 IP unit
. The IP address depends on
there is a DHCP server on the network. If there is, the DHCP ser
assigns an IP address to the
SmartRack 116 IP unit
. If there is no DHCP server, the
unit boots with the static IP address 192.168.2.155.
Open Internet Explorer and type into the Address box:
http://IP
address/config
(Do not start the address with
https.)
he Login page appears.
Figure 68 – Login Page
m
e admin , and in Password, type SAFEmode (
ca
e and pa
ssword works only in Safe mode.)
Figure 69 – Safe Mode Menu
Restoring Factory Defaults
SmartRack 116 IP
settings to their default values.
Troubleshooting
– Safe Mode
Restoring
Factory Defaults
User Guide | 63
Go Local
button on
. The IP address depends on
there is a DHCP server on the network. If there is, the DHCP ser
ver
. If there is no DHCP server, the
address/config
.
ca
se sensitive).