User guide

To align the mouse pointers
1. On the toolbar, select
The mouse pointers a
li
4.9.3
Calibrating Mouse
A target server
may have a different mouse pointer speed than the
Calibrating automatically discovers the mouse speed of the
the two pointers.
You can perform
automatic
Windows NT4, 2000, or 98.
SmartRack 116 IP
saves this alignment so that calibration is only needed once per
target server.
To
perform the calibration
1. On the toolbar, select
If the Video Noise Level is above zero, calibration may not work. In this case, go to
Video Adjustment and try to eliminate the noise by automatically adjusting the video
(see Section 4.7.2
) and/or adjusting the bars in manual video adjust (see Section
4.7.3
), and then performing the mouse calibration
If the mouse settings on the target server
synchronize mouse pointers manually, as explained below.
4.10
Switching to a
In the middle of a remote session, you can switch to a different server.
To
connect to a different server
1. On the toolbar, click
A list of connected se
r
remote session.
2.
Click the desired server.
The screen of the server terminal emulation window appears.
4.11
Disconnecting the Remote Session
To
disconnect the session
1. On the toolbar, click
The Login Web pag
e appe
Conducting
Switching
To align the mouse pointers
:
> Align (or press Ctrl+M).
li
gn.
Calibrating Mouse
Pointers
may have a different mouse pointer speed than the
client computer
Calibrating automatically discovers the mouse speed of the
target server
automatic
calibration when the target server o
perating system is
Windows NT4, 2000, or 98.
saves this alignment so that calibration is only needed once per
perform the calibration
:
> Calibrate.
If the Video Noise Level is above zero, calibration may not work. In this case, go to
Video Adjustment and try to eliminate the noise by automatically adjusting the video
) and/or adjusting the bars in manual video adjust (see Section
), and then performing the mouse calibration
.
If the mouse settings on the target server
have been
changed, you must
synchronize mouse pointers manually, as explained below.
Switching to a
Different Server
In the middle of a remote session, you can switch to a different server.
connect to a different server
:
.
r
vers appears. There is a checkmark near
the server
Click the desired server.
The screen of the server terminal emulation window appears.
Disconnecting the Remote Session
disconnect the session
:
.
e appe
ars. You can re-login or close the brow
ser
Conducting
a Remote Session
Switching
to a Different Server
User Guide | 61
client computer
.
target server
and aligns
perating system is
saves this alignment so that calibration is only needed once per
If the Video Noise Level is above zero, calibration may not work. In this case, go to
Video Adjustment and try to eliminate the noise by automatically adjusting the video
) and/or adjusting the bars in manual video adjust (see Section
changed, you must
In the middle of a remote session, you can switch to a different server.
the server
of the
ser
window.