User guide

KVM.NET
®
II
88
12.2.5.1 Refresh
Select Refresh to refresh the Video image. Refresh may be needed when changing
the display attributes of a Target.
12.2.5.2 Manual Video Adjust
Use the manual video adjustment for fine-tuning the Target video settings after
auto adjustment or for adapting to a noisy environment or a non-standard VGA
signal or when in full-screen DOS/CLI mode.
To adjust the video manually:
Click Manual Video Adjust. The manual controls appear, see Figure 81. Also a
red frame appears around the screen. This represents the screen area according to
the Server's screen resolution. Perform the adjustments inside and relative to this
frame.
Figure 81 Manual Video Adjustments controls
Brightness / Contrast - use the scales to adjust the brightness and contrast of the
displayed image. Move the sliders to change the displayed image. Click in the area
of the sliders for fine-tuning.
For the following controls choose the appropriate measurement.
Horizontal Offset - defines the starting position of each line on the displayed
image.
Vertical Offset - defines the vertical starting position of the displayed image.
Phase - defines the point at which each pixel is sampled.
Scale – defines the scale resolution of the session image.