User guide

USER GUIDE
67
Application / VNC Application Path / Port – these fields are only relevant in
VNC Client mode. The difference between VNC Client and Web mode is detailed
below.
URL/Host: - Type the URL/Host of the VNC resource.
Mode: VNC Client (default)
When using VNC Client mode, the page appears as in see Figure 60.
VNC Client mode uses a VNC console server. In VNC Client the VNC application
must be installed on all client computers, preferably in the same path. Type the
path to the VNC Viewer application. Where the VNCPath is the actual installation
folder of the VNC application, the installation folder depends on the type of VNC:
RealVNC, TightVNC or UltraVNC. See the General notes above about variables.
The VNC application can be obtained from:
• RealVNC: http://www.realvnc.com
• TightVNC: http://www.tightvnc.com/
• UltraVNC: http://www.uvnc.com/
In VNC Client mode, the port number should correspond to the VNC listening
port.
Login Method:
• Prompt for Credentials – this means the VNC login appears and you login
manually.
• Use KVM.net Credentials – this means KVM.net II logs into VNC with
the currently logged user credentials. Ensure that VNC is configured to
recognize the same password.
• Use the Following Credentials – Where the passwords are different for
KVM.net II and VNC, select this option. A Password field appears. Type the
VNC Password. KVM.net II logs into VNC using this Password.
Web mode
In Web mode there is no need for an executable application.
When selecting Web mode, the page appears as in Figure 61.