User guide

KVM.NET
®
II
60
10. Configuring Access Services – introduction
Each Access Service comes with a default settings template. The template values
can be changed from the Settings/Access Services page, see Figure 52.
Checkboxes are greyed
out for factory included
access services – these
cannot be deleted.
Figure 52 Access Services
The template values are automatically applied to new Targets that have the Access
Service assigned to them.
For example, there is a default value for the application path of an access service. If
this is suitable, ensure that all users have the access service application in the same
path on their computer. Where a user computer has a different path, a prompt
appears on the user’s computer asking the user to browse for the Access Service
application on his computer.
Note! Access Service settings can also be changed if necessary, for individual
Targets, explained on page 72.
All the Access Services are reached from the Access Services page, see page 47.
10.1 Access Services default values
Below are the factory included access services and their default values. If these
values are not suitable you can change them. If an Access Service has an
executable application, the application must be installed on all local computers.
10.1.1 General note about application paths
When inputting the application path into the KVM.net II client interface you can
include variables. For example for an access service called ABC service, by typing
“%ProgramFiles%\ABCservice” the application could be installed in any drive on
client computers in the Program Files\ABCservice folder.