User guide

KVM.NET
®
II
44
When there is more than one DXU IP II units or if there are multi-user matrix
KVM switches in the system, you must assign the same Targets to the same ports
for each DXU IP II unit/matrix KVM switch.
1. Assign the ports for one DXU IP II unit/matrix KVM switch.
2. Go to the Devices page and select the next DXU IP II unit/matrix KVM switch.
3. Click the Targets tab and in the Show Targets drop-down menu select All
Targets.
4. Go down the list and again assign the same Targets to the same ports for this
DXU IP II unit/matrix KVM switch.
When selecting a Target the KVM.net II checks which DXU IP II unit/IP device
connected to a matrix KVM switch, is available and automatically connects
you to the chosen Target. If a local DX User is accessing the port View Only is
available.
8.5 Network tab
In the Network tab you configure and modify Network parameters of the IP device.
Click the Network tab. The following appears.
Figure 39 Network tab
Interface I displays the IP address of the IP device as discovered by the KVM.net II
Manager system. You can change this address here.
Enter IP address, Subnet Mask and Default Gateway for the network adapter, as
given by your Network Administrator.