User guide

USER GUIDE

For KVM.net managed select the correct DX configuration with PRT-SCR (and

not Ctrl hotkey), as selected in the KVM Switches page. Once the correct DX

configuration with PRT-SCR is selected, the fields circled in Figure 38 appear.

Figure 38 DXUIP II fields in KVM.net II Managed mode

If this DX User IP II is the IP device connected to User port 1 of the DX Central,

select the Master Console checkbox. (This enables the DX port statuses to be

displayed in the KVM.net II interface). If this unit is not the Master console, select

the User port this device is connected to from the Console port drop-down list and

select the Master device from the Master device drop down list.

Note! When there are more than one DXU IP II units in the system you must select

the KVM switch file for all DXU IP II units.

8.4 Targets

The Targets you created appear in the Targets list.

You can choose to display all Targets or just unassigned Targets (default) or

Targets belonging to a Target set. Select the desired option from the Show Targets

drop-down menu.

You must associate the Targets with the relevant IP device or with the port

numbers on the KVM switch to which they are physically connected.

To associate the Targets:

1. From the Targets list, double-click the Target connected port #1 of the KVM

switch. The Target assigns to the port #1 of the Ports section. Alternatively drag

and drop the Target to the correct port number.

2. Repeat the above step for all Targets connected. Ensure the right Target assigns

to the correctly numbered port.

To remove a Target from a port:

Double-click the Target in the Ports section. The Target name moves to the Target

section and is now unassigned.

Note! Deleting a Target removes its association with the KVM port number. See

page 35.