User guide

KVM.NET
®
II
42
8.3 KVM Ports tab
In the KVM Ports tab you:
• Associate the KVM switches in the system to the relevant IP device
• Associate Targets with the relevant IP device/port number on the KVM
switch
Click the KVM Ports tab, the following appears.
Ports numbers for the
selected KVM switch
appear here
Target servers appear
here
Figure 37 KVM Ports tab
The KVM switch drop-down list consists of pre-selected KVM switches. You must
select all the KVM switch types physically connected to the system, this is done in
the Settings part of the menu and is explained in section 9.2 on page 49. Select the
KVM switch model (if any) physically connected to this IP device. The number of
ports in the selected KVM switch appears in the Ports section.
Notes:
When using a Smart 116 IP, “IP 116” is selected by default and cannot be altered.
When using a Smart 216 IP or Smart 232 IP, “Internal” is selected by default and
cannot be altered.
8.3.1 DXU IP II units
When there are DXU IP II units in the system:
For KVM.net enabled select the correct DX configuration with Ctrl (and not
PRT-SCR hotkey), as selected in the KVM Switches page.