User guide

USER GUIDE
39
Warning – Problem with the device. See the Devices page on page 39 for
more information.
Uploading – Device is receiving new firmware from KVM.net II Manager.
Updating device – Device is receiving an updated configuration from
KVM.net II Manager.
Rebooting - Device reboots upon any Network parameter change, or firmware
upgrade.
Connecting – KVM.net II send or receives the Device Discovery message.
Version – Displays the device firmware version number.
Description – Identifying description of the device as input by the administrator
when configuring the device.
8.1 Setting each IP device to be KVM.net enabled
In order to be managed by KVM.net II, all Minicom IP devices must be configured
to be KVM.net enabled. See section 4 on page 16.
Tip! Since IP devices only appear in the New Devices list once they are KVM.net
enabled, make each IP device KVM.net enabled in a certain order with a suitable
time gap, so that you can identify the unit’s location.
8.2 Configuring the IP devices in the KVM.net II
Configure a new IP device as follows:
1. In the New Devices section click the MAC address of an IP device. The
General tab of the Devices page appears, see Figure 35.
Figure 35 Devices page - General tab
Type – IP device type, PX etc. (Read-only field).