User`s guide

The Slave unit
8-12
5UM20044 Version 10400
Jumper
JP9
Figure 8-8 Jumper JP9
3. Reinsert the
Slave
card, close the cover, reconnect
the power cord, and switch on the computer.
4. Start the
Phantom Update
program, and carry out
the download process again for all the
Slave
computers.
Since Jumper
JP9
is closed the
Phantom Update
program does not show the firmware version number
after completing the download.
5. Switch off the
Slave
computer and disconnect the
power cord.
6. Open the cover, extract the
Slave
Card and open
Jumper
JP9
.
7. Reinsert the
Slave
card, close the cover, and
reconnect the power cord.
8. Check that the system functions properly.