User`s guide

Password protecting the OSD
7-7
For the Box version
1. Switch off the computer and
Manager
box.
2. Disconnect the power cord and all other cables from
the
Manager
box.
3. Remove the cover of the
Manager
box.
4. Locate Jumper
JP4
and close it. See Figure 7-1 on
page 7-2 above, and Figure 7-6 above.
5. Replace the cover of the
Manager
box.
6. Reconnect the power cord and all cables, and switch
the
Manager
unit on.
7. Wait ten seconds. Switch off, and disconnect the
power cord and all cables.
8. Unscrew the cover of the
Manager
box.
9. Open Jumper
JP4
.
10. Replace the cover of the
Manager
Box.
11. Reconnect the power cord and all cables, and switch
on.
Note!
If the system fails to recognize the default
password, check that Jumper
JP4
is open.