User`s guide

Password protecting the OSD

7-3

4. Replace the

Manager

card

and the computer’s cover.

5. Reconnect the power cord and all cables, and switch

the computer on. Password protection is now

enabled.

For the Box version

1. Switch off the

Manager

box and computer.

2. Disconnect the power cord and all other cables from

the

Manager

box.

3. Unscrew the back of the

Manager

box.

4. Locate Jumper

JP2

and open it. See Figure 7-1 and

Figure 7-2 above.

5. Replace the back of the

Manager

box.

6. Reconnect the power cord and all cables, and switch

on. Password protection is now enabled.

Entering a password

Once password protection is enabled, you can only access

the OSD by entering the appropriate password.

The default Administrator’s password is “ADMIN”. The

passwords of the other two security statuses are set by the

Administrator – see the paragraph below.

To access the OSD:

1. Press

Shift

. The

Enter Password

box appears.

See Figure 7-3.

Figure 7-3 The Enter Password box

2. Type in the appropriate password.

3. Press

Enter