User`s guide

The OSD functions
6-15
For the Box version
1. Switch off the
Manager
box and computer.
2. Disconnect the power cord and all other cables from
the
Manager
box.
3. Unscrew the back of the
Manager
box.
4. Locate Jumper
JP3
and close it. See Figure 6-8, and
Figure 6-9 above.
5. Replace the back of the
Manager
box.
6. Reconnect the power cord and all cables, and switch
on.
7. Wait ten seconds. Switch off, and disconnect the
power cord and all cables.
8. Unscrew the back of the
Manager
box.
9. Open Jumper
JP3
.
10. Reinsert the
Manager
card and replace the back of
the Box.
11. Reconnect the power cord and all cables, and switch
on.
Once you adjust jumper
JP3
the OSD appears as in
Figure 6-1 on page 6-1.