Installation guide

INSTALLATION GUIDE
33. Connecting the RS232 Serial cable
To operate the Phantom system with the Control software located on the
Marketing & Documentation CD, connect the RS232 Serial cable.
To connect the RS232 Serial cable:
1. Connect the cable’s RJ11 connector to the MX IP’s Service connector. See
Appendix A for the Service Connector Pin-out.
2. Connect the cable’s DB9F connector to a Serial port on the computer’s rear
panel.
The figure below illustrates the connections.
SD
P110
To computer’s Serial port
Computer screens
appear here
Control software
installed here
To Service
connector
RS232 Serial
cable
MX IP
www.minicom.com
POWER
85-265VAC 50/60 Hz
COMPUTER
SYSTEM2
nd
USER OUT IN SERVICE
RST
SERIAL 3
ETHERNET
USER
SERIAL 1
SERIAL 2
Figure 20 The MX IP with the RS232 Serial cable
20