User guide

Configuring the Network
Configuring User Targets
User Guide | 39
3. Select the High security password policy checkbox to enable the high security
password policy; clear the checkbox for the standard security policy to apply.
4. Select the Enable OSD password checkbox, to require a password for local user
access to the OSD. By default, password is disabled.
5. In Disconnect after, select the timeout inactivity period after which the user is
disconnected from the system. Select No Timeout to disable timeout.
6. To use your preferred SSH client to communicate directly to the serial device via
the specified TCP ports:
1. Select the Enable direct SSH Connection checkbox.
2. Select Serial 1 TCP port and Serial 2 TCP port values. Their default ports are
4001 and 4002, respectively.
3.9 Configuring User Targets
By default, administrators are allowed access to all servers. For other users, you must
define the access rights of each user separately.
Perform the following procedure for each User.
To configure User targets:
1. From the configuration menu, select User Targets.
The User Targets page appears.