User guide

Troubleshooting – Safe Mode
Entering Safe Mode
User Guide | 63
To enter Safe mode:
1. While powering up Smart 108/116 IP, press and hold down the
Go Local button on
the back panel of the unit for three to four seconds.
The device boots up in Safe mode.
2. Wait until the unit finishes booting (one to two minutes).
3. Determine the IP address of the Smart 108/116 IP unit. The IP address depends on
whether or not there is a DHCP server on the network. If there is, the DHCP server
assigns an IP address to the Smart 108/116 IP unit. If there is no DHCP server, the
unit boots with the static IP address 192.168.2.155.
4. Open Internet Explorer and type into the Address box: http://IP address/config
.
(Do not start the address with https.)
The Login page appears.
Figure 46 – Login Page
5. In User, type username admin , and in Password, type SAFEmode (case sensitive).
(This username and password works only in Safe mode.)
A menu appears.
Figure 47 – Safe Mode Menu