User guide

Configuring the Network
Configuring the Security Settings
User Guide | 37
Standard Security Policy High Security Policy
At least six characters At least eight characters; must include at least one digit, one
uppercase letter, and one of the following “special” characters: !, @, #,
$, %, ^, *, (), _, -, +, =, [], ’, :, ;, ?, /, or {}
Must not include the user name Must not include the user name
To configure the security settings:
1. From the configuration menu, select Security
.
The Security page appears.
Figure 21 – Security Page
2. In the Account Blocking section:
 In Block after, type the number of allowable attempts to log in with a wrong
username or password in a time period specified in attempts within, prior to a
forced time lock.
 In Block account, select for period to block the account for a specified period of
time, or forever for a total block.
3. Select the High security password policy checkbox to enable the high security
password policy; clear the checkbox for the standard security policy to apply.
4. In Disconnect after, select the timeout inactivity period after which the user is
disconnected from the system. Select No Timeout to disable timeout.