User guide

USER GUIDE
several pre-settings (i.e. last day, last week) or an exact declaration of the start and
the end date.
Once you change the filter settings, click `Update' to update the shown entries. If the
Get sensor names box is checked, all sensor IDs are shown with their respective
names.
The time shown in the log entries is the SEL time, meaning it is independent of the
system time. The SEL time is shown at the top of the log table. Click Clear Event
Log to delete all entries in the SEL repository.
42. Power Control
The appearance of the power control window depends on the power control option
connected to IP Extender and on the currently activated setting (discussed on page
48). There are three options available: Power control disabled. Internal power.
External power.
Internal power
Once connected enable the internal power option using the serial settings on page
44.
The Power Control panel enables access to the most important external buttons of
your host system. These buttons are the reset and the ATX power button.
The power button represents the ATX power button on your host system. It is used
to switch the power supply on and off. The ATX power button has 2 operation
modes: a short press, and a press of about 4 seconds. As shown in Figure 18 these
two modes are supported separately. The 2 operation modes are explained in the
next section.
Figure 18 Internal Power Control
Note: The prerequisite for the remote power/reset button to work is a correct
installation of IP Extender.
28