User guide

IP CONTROL
17
17. Administration > Serial Settings
Where you have a Serial device connected to the system you must configure the
RS232 settings.
To do so:
From the menu click Serial Settings, the Serial Settings appear, see Figure 15.
Figure 15 Serial Settings
Type a device name and choose the correct device parameters.
Note! Where you have a Minicom Serial Remote Power Switch connected, see
below Assign to RPS.
17.1 Show
Tick Show to make the Serial device appear in the list of servers/devices that can
be accessed.
17.2 Assign to RPS
Where a Minicom Serial Remote Power Switch (RPS) is connected to the Serial
port, tick this box. All other parameters are then grayed out. See the RPS
Installation Guide for further information on installing and operating the RPS.