User guide

DX USER IP II
33
To display the Toolbar repeat the above actions. See also page 43.
22.1.2 Accessing a server/device
To connect to a server/device:
Important!
Accessing or switching to the servers from the IP toolbar only works when the DX
AIM is on the Servers/Devices page, see Figure 24.
1. Select View/Servers/Devices to display the Servers/Devices page.
2. From the Toolbar, click , or right-click . A list of connected
servers/devices the user has permission to access appears. Note! These are the
server names as configured in the IP interface and not the DX AIM interface – we
recommend giving the servers the same names in both the IP and DX portions.
3. Click the desired server or Serial device. The screen of the server or the Serial
device window appears. See Figure 34.
4. To switch to a different server repeat steps 1 and 2 above.
5. To display the DX AIM press the left Shift key twice.
6. On logging out and then logging in again, the screen of the last accessed
server/device appears.