User guide

DX USER IP II

21.1 Connecting more than one DXU IP II to the system

When there are more than one DXU IP II units in the system you must do the

following:

1. Select the KVM switch file for all DXU IP II units. So follow steps 3 – 7 above

for each DXU IP II unit.

2. In Device Properties click the Targets tab, see Figure 33. Here you assign the

Target servers to the specific ports of the DXU IP II unit. You must assign the

same Targets to the same ports for each DXU IP II unit.

3. Assign the ports for one DXU IP II unit

4. Go to the Devices page and select the next DXU IP II unit,

5. Click the Targets tab and in the Targets drop-down menu select All Targets

6. Go down the list and again assign the same Target servers to the same ports for

this DXU IP II unit.

When selecting a port the KVM.net checks which DXU IP II unit is available and

automatically connects you to the chosen Target. If a local DX User is accessing

the port View Only is available.

For all other configuration settings see the KVM.net User Guide.

Figure 33 Targets tab