User guide

DX USER IP II
23
Figure 22 Reboot
3. Click Reboot to restart the unit.
19. Saving changes
Click to save configuration changes and restart the DXU IP II.
Only one Administrator can log into the Configuration area at a time. An idle
timeout of 30 minutes terminates the session.
For Standalone and KVM.net enabled and managed modes the DX AIM needs to be
configured, see the next section.
20. Configuring the DX AIM
Configuration of the DX system depends on how the DX User IP II is being used -
Standalone or KVM.net managed. The sections below explain how to configure the
system for each mode.
1. From a remote computer console open Internet Explorer (6.0 and above) and type
the DXU IP II’s IP address. https://IP address. (Note! Only SSL connections are
allowed, therefore type HTTPS before the IP address or the name of the DXU IP
II). The DX Login page appears, see Figure 23.
Or at the DXU IP II local console once the system is connected and powered on the
DX Login page appears, see Figure 23.
Figure 23 DX Login page
2. Type the username and password and press Enter. By default, the user name is:
admin and the password is admin, (both lower case).