User guide

DX USER IP II
17
13. Administration > Serial Settings
Note! This section is only relevant to Standalone mode.
Where you have a Serial device connected to the DXU IP II you must configure the
RS232 settings.
To do so:
From the menu click Serial Settings, the Serial Settings appear, see Figure 12.
Figure 12 Serial Settings
Type a device name and choose the correct device parameters. Note! Where you
have a Minicom Serial Remote Power Switch connected, see below Assign to RPS.
13.1 Show
Tick Show to make the Serial device appear in the list of servers/devices that can be
accessed during a remote session.
13.2 Assign to RPS
Where a Minicom Serial Remote Power Switch (RPS) is connected to the Serial
port, tick this box. All other parameters are then grayed out. See the RPS Installation
Guide for further information on installing and operating the RPS.