User guide

DX USER IP II
13
10.1 LAN 1
Under LAN 1 in Figure 9, is the following:
Enable DHCP – When a DHCP server is active on the same network to which
DXU IP II is connected, DHCP provides automatic IP assignment.
When DHCP is disabled – (Recommended) – You can assign a fixed IP address to
the DXU IP II.
Consult your Network Administrator regarding the use of the DHCP. Note! Where
you have access to the server – your configured (or default) DXU IP II device name
will appear on the DHCP server’s interface, making it easy to locate.
When DHCP is disabled, enter the IP Address, Subnet Mask, and Default
Gateway for LAN 1, as given by your Network Administrator.
10.2 KVM.net
Standalone mode – The Enable KVM.net box must be unselected. Go straight to
section 11 Administration > User Settings.
KVM.net enabled/managed - The Enable KVM.net must be selected to allow
DXU IP II unit to be remotely managed by Minicom’s KVM.net system.
Manager Auto Discovery – when checked, KVM.net automatically detects the
DXU IP II, if it resides on the same network segment.
Manager IP – If DXU IP II resides on a different segment, type the static IP address
of the KVM.net Manager. (We advise typing the static IP address of the KVM.net
Manager even if the DXU IP II resides on the same network segment as the
KVM.net Manager).
For KVM.net enabled/managed go straight to section 19 Saving changes, on page
23. Once the DXU IP II is KVM.net enabled, all device configuration settings are
done via the KVM.net interface.