User guide

DX USER IP II
11
Note! If a DHCP server later becomes available, the unit picks up the IP settings
from DHCP server. To keep the static IP address, disable DHCP – explained in
section 10.1 on page 13.
9.2 Static IP addresses for a number of units
Where you want to connect more than 1 DXU IP II to the same network and there is
no DHCP server, or you want to use static IP addresses, do the following:
Connect the DXU IP II units one at a time and change the static IP address of each
unit before connecting the next unit.
9.3 Logging into the Web interface
Complete the initial setup via the Web configuration interface:
1. Open your Web browser (Internet Explorer version 6.0 or higher).
2. Type the DXU IP II system IP address - https://IP address/config - and press
Enter. The login page appears, see Figure 8.
Figure 8 Login page
3. Type the default Administrator user name - admin - and password - access -
(both lower case).
4. Press Enter. The Web interface opens at the Network Configuration page. See
Figure 9.