User Guide switch DX System
Table Of Contents
- Welcome
- 1. Introduction
- 2. Pre-installation guidelines
- 3. DX system outline
- 4. Connecting the DX system
- 4.1 Connecting an optional local computer to a DX User
- 4.2 Connecting servers to the DX Central
- 4.3 XRICC power supply
- 4.4 Connecting a RICC or XRICC PS/2
- 4.5 Connecting an XRICC SUN
- 4.6 Connecting an XRICC USB
- 4.7 Connecting an XRICC RS232
- 4.8 Connecting the CAT5 cables
- 4.9 Connecting the DX User to an RS232 Terminal
- 5. Power management
- 6. Connecting Legacy KVM switches
- 7. Cascading DX Central units
- 8. Powering on the system
- 9. Configuration wizard (non-DX cascaded system)
- 10. Logging in
- 11. Configuring the DX system
- 12. Creating/editing Users and Groups
- 13. Arranging devices
- 14. Scanning a group of servers
- 15. Adjusting the picture quality
- 16. Connect - Private
- 17. Disconnect User
- 18. Connecting to a local computer
- 19. Updating the DX Central
- 20. Updating the DX User and XRICCS/RICCs
- 21. Events log
- 22. Troubleshooting - Resetting the DX Central
- 23. USB / SUN Combo keys
- 24. Technical specifications
- 25. Terminal hotkeys
- 26. User guide feedback
DX SY
STEM
15
4.6 Connecting an XRICC USB
The XRICC USB supports Windows 98 SE and later, MAC, SUN and SGI. Figure
13 illustrates the connections.
To connect the XRICC USB:
1. Connect the Screen connector to the server’s Video card.
2. Connect the USB connector to the server’s USB port.
To USB Port
To Video Card
CAT5 cable to DX Central
Server port
X-RICC USB
Figure 13 XRICC USB
4.7 Connecting an XRICC RS232
Figure 14 illustrates the connections.
To connect the XRICC RS232:
1. Connect the RS232 connector to the server’s RS232 port.
2. For power connect either:
A USB cable to the XRICC and the server’s USB port.
Or
A Power adapter to the XRICC.