User guide

DX POWER SWITCH 8 PORT
7
Configure the Network parameters.
The default Network parameters are as follows:
IP address 192.168.100.100
Subnet mask 255.255.255.0
Gateway No address
Port 80
To configure all other parameters, click .
General Tab
Define all the Network parameters of the DX Power Switch-Standalone (IP
Address, Subnet Mask, Default Gateway and Port Number).
Permit or deny the configuration using the DX Power Switch Finder program for
security reasons.
Labels Tab
Assign a label to a group of DX Power Switch devices connected together (a group
is made of 1 DX Power Switch Standalone and up to 4 Slaves).
Assign a label to each DX Power Switch and its 8 power sockets (use the left
vertical Tabs to select the DX Power Switch you want to configure).
Accounts Tab
In combination with the left vertical tab Group, this tab is used to give a name and
password to the administrator who has access to all the sockets within a group of
DX Power Switches.
In combination with one of the left vertical tabs «Device 1» to «Device 5», this tab
is used to define 8 user accounts using a name and a password for each one.
Define the power sockets each user can control.
Activate or deactivate a DX Power Switch-Slave connected to the Standalone.
Define the function mode of each DX Power Switch (Single mode or Twin mode):
· Single mode enables you to control each power socket individually.
· Twin mode enables you to control 2 power sockets with 1 command. This
mode is particularly intended to restart devices using redundant power
supplies. In this case, the 4 sockets powered by power supply A (sockets 1
to 4) are automatically associated with the 4 sockets powered by power
supply B (sockets 5 to 8) and the labels of the first 4 sockets are used.