User guide

DX POWER SWITCH 8 PORT
23
9.600 bauds, 8 bits, no parity, 1 stop bit and no flow control.
If you use the MicroTerminal program on the CD you only have to choose the used
Serial port, this program is already configured at 9600, n, 8,1.
4. From your computer, enter the command as explained below.
The syntax of the command line is: Pxy=z
Parameter Value Function
x 1 to 4 1 to 4 means the corresponding connected Slave
y 0
1 to 8
All sockets must be controlled together
The number of the socket you want to control
z 0 Command to switch the socket (Slave) OFF
1 Command to switch the socket (Slave) ON
r Command to restart the socket (Slave)
t Command to toggle the state of the socket
Example - Controlling the first Slave
Dipswitch: 1 = off and 2 = off
P10=1 Enter switch all 8 sockets ON
P10=0 Enter switch all 8 sockets OFF
P14=r Enter restart socket 4
P18=t Enter toggle socket 8
Example - Controlling the second Slave
Dipswitch: 1 = on and 2 = off
P20=1 Enter switch all 8 sockets ON
P25=0 Enter switch socket 5 OFF
The DX Power Switch accepts lower and upper case commands.
The DX Power Switch sends an echo for each received character.