User guide

DX POWER SWITCH 8 PORT
13
Command 1
GROUP NAME SETTING
Group Name is: Device Name
Enter Name (max. 32 characters) or <ESC> to exit
>
Command 2 to 6
DEVICE 1 / SOCKET NAMES SETTINGS
1. Device Name Device 1 name
2. Socket 1 Socket 1-1 name
3. Socket 2 Socket 1-2 name
4. Socket 3 Socket 1-3 name
5. Socket 4 Socket 1-4 name
6. Socket 5 Socket 1-5 name
7. Socket 6 Socket 1-6 name
8. Socket 7 Socket 1-7 name
9. Socket 8 Socket 1-8 name
Enter Selection or <ESC> to exit
Device Parameters Settings
Command /DP
Configure an Email address, to which the user can send a message in case of
problems.
Define the function modus of each DX Power Switch device (Single mode or Twin
mode):
Single mode enables you to control individually each power socket.
Twin mode enables you to control two power sockets with one command. This
mode restarts devices using redundant power supplies.
In this case, the 4 sockets powered by power supply A (sockets 1 to 4) are
automatically associated to the 4 sockets powered by power supply B (sockets 5 to
8) and the labels of the first 4 sockets are used.
Activate or deactivate a DX Power Switch Slave connected to a DX Power Switch
Standalone.
DEVICE PARAMETERS SETTINGS
1. Mail to
2. Device #1 Activated Twin Mode