User guide

DX POWER SWITCH 8 PORT
9
5. Press the TAB key. The Configuration menu appears and the DX Power
Switch-Standalone is in Configuration mode. Follow the menu below to
configure the DX Power Switch-Standalone Web server.
Figure 3 Configuration menu
All commands start with a slash /.
ex.: type the command /NP to go to the Network Parameters settings menu.
To display the current menu again, press Enter.
To display the previous menu, press Esc.
To leave the Configuration mode, type the restart command /RS. This is important
if you want to control the power socket later through the serial connection.
The configuration of the Serial port is explained in section 10 on page 18.
Configuration Mode Main Menu
The configuration mode Main menu displays all the commands that can be used.
(example: type the command /NP to go to the Network Parameters settings menu.
To display the current menu again, press Enter.
To display the previous menu, press Esc.