- Data Communications Operator's guide Ethernet CMG-DCM

CMG-DCM
will be several sender pages, all with the same options.
datatransfer.cd1.sender : Select on to activate the CD1.0 sender. If you do not
want the DCM to transmit CD1.0 data, select off and ignore the remaining
settings.
datatransfer.cd1.sender.sitename : The CD1.0 site name for the DCM.
datatransfer.cd1.sender.receiver : The IP address or hostname of the remote
CD1.0 device.
datatransfer.cd1.sender.port : The network port number to which the DCM will
send CD1.0 data.
datatransfer.cd1.sender.compression : Select on to enable Canadian
compression in the outgoing data stream.
datatransfer.cd1.sender.channel.x : The DCM needs to know the CD1.0
channel name for each of the streams you want to transmit. When data comes in
on a stream that the DCM recognizes, it will send it on with this new name.
You can set up to 12 channels to be transmitted by one CD1.0 sender.
CD1.1
The CD1.1 format is an evolution of CD1.0 used by many NDCs, using
different settings from CD1.0. The DCM has a separate transmitter for this
format.
datatransfer.cd1_1.tx : Select on to instruct the DCM to provide data in this
format. If you do not want the DCM to transmit CD1.1 data, select off and
58 Issue A