Instruction manual

6
ASSEMBLY INSTRUCTIONS
Please take the time to review all instructions and drawings before building the kit. Each step will list bags, tools
and parts required to proceed. Any position calling for the installation of steel threaded hardware into non-locking
threads will refer to the addition of Blue Loctite thread locker (included). Any position using steel hardware into
plastic will refer to the addition of slow Cyanoacrylate glue (CA) (not included) as a thread locker. Always clean
the threads with alcohol and use the locking material sparingly.
For individuals wishing to know, the following maximum
torque values apply to metal to metal positions on the
model:
Bolt Size
NCM (Metric) Inch/Pounds (U.S.)
M3 40.0 3.5
M4 70.0 6.2
This information is provided only for interest and in no way indicates that a torque wrench is needed to
successfully build the model.
When installing hardware into plastic, be aware that a) threads are forming so hold the item straight while
tightening and b) you must stop tightening as soon as the flange or head contacts the plastic surface.
Frequently, the text will refer to items known as APEM@ nuts. These are M2.5 and M3.0 threaded steel inserts that
are factory installed in both side frames and various frame channels used in the kit. They are non-locking and
require the use of Blue Loctite on any related bolts or screws. Do not attempt to remove them and avoid over-
tightening hardware into them. They are quite secure with only minimal tightening and use of Blue Loctite.