Technical data

Driving precautions DRIVING HINTS
97
1. Reach into the recess, arrow 1, on the rear
edge of the luggage compartment floor.
2. Lift luggage compartment floor at rear and
fold forwards, arrow 2.
Before closing the tailgate, unhook the loops
and fold the luggage compartment floor back
down into the flat position.
Removal
The luggage compartment floor can be removed
if required. To do this raise luggage compart-
ment floor at recess, fold it together and take it
out.
Partition net*
Make sure that the partition net is firmly
secured, as otherwise injuries could
result.<
Before installing
1. Take the bag containing the partition net
out of the storage compartment underneath
the luggage compartment floor.
2. Take the partition net out of the bag and
unroll and unfold the net.
When you have finished using it, fold and roll
the partition net back up and put it back in
the bag so that it can be stowed underneath
the floor panel again. Keep hooks and ten-
sioning clasps away from bar elements.
3. Fold out the partition net until the bar ele-
ments engage.
Installation behind the front seats
1. Remove the roller cover for luggage com-
partment if necessary.
2. Folding down the rear seat backs, see
Expanding the luggage compartment.
3. Push each of the securing pins of the parti-
tion net as far as they will go into the front
mountings in the headlining, arrow 1, and
push forwards.
4. Attach the hooks, arrow 2 underneath the
straps to the eyes in both sides of the vehicle
floor.
5. Secure the partition net by tightening the
straps on the tensioning clasps.
Removing
To remove and stow the partition net, proceed
in reverse order.
To roll the net up, press the release button,
arrow.
Online Edition for Part no. 01 40 2 607 512 - © 03/11 BMW AGOnline Edition for Part no. 01 40 2 607 512 - © 03/11 BMW AG