Technical data

Adjusting CONTROLS
35
Refit the head restraint before driving with
passengers, otherwise there is no protec-
tive function.<
Front
1. Pull up all the way.
2. Fold the backrest back slightly.
3. Press the button 1 and pull the head
restraint out as far as it will go.
4. In addition, use a suitable tool to press the
button 2 and pull the head restraint fully
out.
5. Fold back the backrest.
Rear
1. Pull up all the way.
2. Fold the backrest forward slightly.
3. Press the button 1 and pull the head
restraint fully out.
4. In addition, use a suitable tool to press the
button 2 and pull the head restraint fully
out.
5. Fold up the rear seat backrest.
Seat heating*
Switching on
Press once per temperature stage.
Three LEDs indicate the highest temperature.
If you continue driving within 15 minutes, the
seat heating is automatically activated at the
previously set temperature.
The temperature is reduced, if necessary includ-
ing switching the heating off, to save the bat-
tery.
The LEDs remain lit.
Switching off
Press and do not immediately release the but-
ton.
Seat belts
Comply with the instructions on page 33,
or there will be greater risks to personal
safety.<
Seat belts are designed to bear upon the
bony structure of the body and should be
worn low across the front of the pelvis, or the
pelvis, chest and shoulders, as applicable. Wear-
ing the lap section of the belt across the abdom-
inal area must be avoided.
Seat belts should be adjusted as firmly as possi-
ble, consistent with comfort, to provide the pro-
tection for which they have been designed. A
slack belt will greatly reduce the protection
afforded to the wearer. Care should be taken to
avoid contamination of the webbing by pol-
Online Edition for Part no. 01 40 2 607 512 - © 03/11 BMW AGOnline Edition for Part no. 01 40 2 607 512 - © 03/11 BMW AG