Technical data

ManualsBrandsMini ManualsOtherRADIO BOOST CD

161

162

163

164

165

166

167

168

169

170

Replacing parts MOBILITY

163

Do not let the compressor run for

more than 10 minutes. Otherwise the

device will overheat and could be dam-

aged.<

8. Switch off the compressor.

If a pressure of 1.8 bar/26.1 psi is not achieved:

1. Remove the filling hose 2 from the wheel

and drive forwards and backwards for

approx. 10 m, approx. 32 ft, to allow the

sealant to spread inside the tyre.

2. Inflate the tyre with the compressor again.

If a tyre pressure of 1.8 bar/26.1 psi still

cannot be achieved, the tyre damage is

too severe. Contact your nearest MINI Service

Centre.<

Stowing the Mobility System

1. Unscrew the filling hose 2 for the sealant cyl-

inder from the wheel.

2. Unscrew the compressor's connecting

hose 6 from the sealant cylinder.

3. Connect the filling hose 2 for the sealant cyl-

inder to the free connection on the sealant

cylinder.

This stops the rest of the sealant escaping

from the bottle.

4. Pack the empty sealant cylinder to avoid

soiling in the luggage compartment.

5. Secure the Mobility System in the vehicle.

Spreading the sealant

Immediately drive for approx. 5 km, approx.

3 miles, so that the sealant can spread evenly.

Do not exceed a speed of 80 km/h,

approx. 50 mph.

If possible, maintain a speed of at least 20 km/h,

approx. 12 mph.<

Correcting the tyre inflation pressure

1. Stop in a suitable location after a distance of

approx. 5 km, approx. 3.5 miles, or

10 minutes.

2. Screw the connecting hose 6 of the com-

pressor directly onto the tyre valve.

3. Insert the plug 5 into the socket on the

inside of the vehicle.

4. Correct the tyre inflation pressure to 1.8 bar/

26.1 psi. For this purpose, carry out the fol-

lowing while the engine is running:

> Increase the tyre inflation pressure: switch

on the compressor. Switch of the compres-

sor to check the currently set tyre inflation

pressure.

Do not let the compressor run for

more than 10 minutes. Otherwise the

device will overheat and could be dam-

aged.<

> Reducing tyre inflation pressure: press the

deflation button 9.

If the tyre inflation pressure is not main-

tained, drive the vehicle again, see

Spreading the sealant. Subsequently repeat

steps 1 to 4.

If a tyre pressure of 1.8 bar/26.1 psi still cannot

be achieved, the tyre damage is too severe. Con-

tact the nearest MINI Service Centre.<

Resuming the journey

Do not exceed the maximum speed of

80 km/h, approx. 50 mph, to avoid the

risk of accidents.<

Have the defective tyre replaced as soon as pos-

sible, and the wheel and tyre rebalanced.

Have the Mobility System refilled.

Changing a wheel

The bag containing the kit for changing a

wheel

* is stored underneath the flat luggage

compartment floor

*. The kit contains: