User Guide

45
NAVIGATION OVERVIEWCOMPUTERINDEX
TRAVELING TIME DISTANCE FUEL CONSUMPTION
The "Travel time" function provides you
with the estimated remaining travel time.
The navigation computer bases its calcula-
tions on the projected travel route, the type
of route and your average road speed.
Requirement:
>The destination guidance system of the
GPS navigation system has been
activated, refer to page 32.
The travel time is automatically adopted.
The "Travel time" function consists
exclusively of a passive display
provided in units based on the selections
you have made in the "Settings" mode,
refer to page 17.<
The display appears in the full screen
view at the upper right, refer to
page 15. In the split screen view, this only
takes place with the destination guidance
system active in the lower right-hand half
of the screen, refer to page 32.<
The "Distance" function displays the dis-
tance remaining to the destination.
Requirement:
>The destination guidance system of the
GPS navigation system has been
activated, refer to the information begin-
ning on page 32.
The following calculation steps are run
through after the destination guidance sys-
tem is started:
>Bee-line between starting and destina-
tion position as basis
>Approximation in the route calculation
still running
>Adjustment of the value to the
calculated route shown with the maps.
As a result, the distance value initially
shown may change until the entire route is
calculated, refer to page 32.
The "Distance" function consists
exclusively of a passive display pro-
vided in units based on the selections you
have made in the "Settings" mode, refer to
page 17.<
The display is shown in the same
manner as for the travel time.<
You can have the average fuel consump-
tion displayed for two different distances,
e.g. such as a complete journey, a single
stretch or following a stop to refuel. The
average fuel consumption is calculated for
the time during which the engine is run-
ning.
With the ignition key in position 1 or
higher, to start calculating fuel consump-
tion:
1. Select "Consumpt. 1" or "Consumpt. 2"
2. Select "Recalculate".
The display is set to zero and the system
begins recalculating the average fuel
consumption.
Online Edition for Part No. 01 41 0 157 018 - © 01/03 BMW AG