Instruction manual

8
hEliCopTER ChARGinG inSTRUCTionS
Note: Charge the helicopter battery before using your Mini Twister Sport for the
first time.
1. Turn on the computer power switch
2. Plug the USB charge lead into a spare USB slot in the computer
3. Carefully connect the battery to the charge lead ensuring it is the correct way
around. You should not need to force it. The light on the USB charge lead will
glow solid RED.
FORCING THE CHARGE PLUG IN THE WRONG WAY AROUND
MAY DAMAGE THE FLIGHT BATTERY OR ELECTRONICS.
4. When the battery has finished charging the light will go off.
5. Disconnect the battery from the charge lead.
pREpARinG FoR FliGhT
TURNING ON
1. Before setting the ON/OFF switch of the transmitter to ON, make sure the throttle
stick is down, in its lowest position.
2. Set the ON/OFF switch of the transmitter to ON. The LED above the ON/OFF
switch will glow RED.
Note: Always turn your transmitter ON first, then your helicopter.
3. Align the red identifying arrows and carefully push the battery into the battery
bay in the bottom of the helicopter taking care to connect it the correct way
round. You should not need to force it.
4. The internal LED will flash quickly and then go solid, this means the helicopter is
bound to the transmitter and ready to fly.
Note: If the light does not go solid and continues to flash see “BINDING THE
TRANSMITTER AND RECEIVER” on page 7.
5. Place the helicopter on the ground with its tail facing towards you.
6. Make sure you have a clear indoor space of at least 3 metres wide and two
metres high when you are learning to fly.