User guide

Mini PTZ Dome Camera User Guide
Document 800-06705 - Rev A - 12/10
43
Group Setup
 Group Edit
z Group Number [1~8]
Selects a Group number to edit.
If the selected Group number is not defined,
UNDEFINED is displayed under the selected Group
number.
z Clear Group [CANCEL/OK]
Deletes the data of the selected Group.
z Run Group Runs the Group for the test purposes to check if it
works properly.
z Edit Group Edits the selected Group.
c Press the Near key when the cursor is at “NO” to start editing the
selected Group.
d Note that maximum 20 actions are allowed in a Group. Move the
cursor up/down to select an Action. Press the Near key to edit the
Action.
e Define Action, Dwell Time and Option. Move the cursor using the
Left/Right arrow buttons of your controller to select an item. Move the
cursor using the Up/Down arrow buttons on your controller to change
each parameter.
z ACTION
[NONE/PRESET/SWING/PATTERN]
z DWELL [0 SEC. ~ 4 MIN.]
Sets the Dwell Time between functions.
z OPT Option. It is the Preset speed when the
selected action is a Preset. It is the number of
repeats when the selected action is a Pattern
or Swing.
GROUP SETUP
------------------------
GROUP NO. 1
UNDEFINED
CLEAR GROUP CANCEL
RUN GROUP
<EDIT GROUP>
BACK
EXIT
EDIT GROUP 1
------------------------
NO ACTION ### DWELL OPT
------------------------
1 NONE
2 NONE
3 NONE
4 NONE
5 NONE
------------------------
SAVE
CANCEL [NEAR:EDIT]
EDIT GROUP 1
------------------------
NO ACTION ### DWELL OPT
------------------------
1 NONE
2 NONE
3 NONE
4 NONE
5 NONE
------------------------
SAVE [NEAR:EDIT ACT]
CANCEL [FAR :EDIT END]
EDIT GROUP 1
------------------------
NO ACTION ### DWELL OPT
------------------------
1 NONE
2 NONE
3 NONE
4 NONE
5 NONE
------------------------
SAVE [ :MOVE CURSOR]
CANCEL [ :CHANGE VAL.]