User guide

Mini PTZ Dome Camera User Guide

Document 800-06705 - Rev A - 12/10

Preset

z Function Maximum 127 positions are programmable. Any number between 1 and 128 can be

assigned to a Preset, except 95. Preset 95 is reserved for entering the OSD menu.

Camera parameters such as White Balance, Auto Exposure and others can be set up

independently and each preset can have its own parameter values independently from

other presets. When setting up presets with a controller, Label should be blank and

"Camera Adjust" should be set to "GLOBAL" as the default. To change the parameters,

enter the OSD menu.

z Setting Presets Set Preset [1~128]

z Running Presets Go to Preset [1~128]

z Deleting Presets Use the OSD menu to delete Presets.

Swing

z Function This function causes the camera to move repetitively between two preset positions at

programmed speeds. When the Swing function is enabled, the camera moves from the

Preset assigned as the first point to the Preset assigned as the second point in a clockwise

direction. Then the camera moves from the Preset assigned as the second point to the

Preset assigned as the first point in a counterclockwise (CCW) direction.

Where the Preset assigned as the first point and the Preset assigned as the second point

are same, the camera turns on its axis by 360° in a clockwise direction and then it turns

back on its axis by 360° in a counterclockwise direction. The Swing speed is defined from

1°/sec to 180°/sec.

z Setting Swings To set a Swing, enter the OSD menu.

z Running Swings Method 1) <Run Pattern> [Swing no. + 10]

Method 2) <Go Preset> [Swing no. + 140]

For example, Run Swing 3: <Run Pattern> [13]

For example, Run Swing 3: <Go Preset> [143]

z Deleting Swings To delete a Swing, enter the OSD menu.

1st Preset

2nd Preset