User's Manual

C-16 Actiwatch Hardware

• Use a finger on the other hand to guide the O-ring into the channel.

• Be sure that the O-ring is properly seated in the channel, and is not twisted

or deformed.

o-ring channel

6. Place a new battery into the Actiwatch case, positive (+) side up as shown

below.

7. Replace the back cover on Actiwatch and replace the screws. If the screws

have not been removed completely, rotate the back cover counterclockwise

until the slots in the back are firmly seated around the screws, and the back is

square with the case.

8. Tighten all four screws in an “X” pattern until all screws are snug. Take care

not to over-tighten to the extent of stripping the threads or twisting off the

heads.

CAUTION! DO NOT over tighten the screws. They can be easily stripped.