User's Manual

C-14 Actiwatch Hardware
CAUTION! To retain the integrity of the waterproof seal, it is
recommended that you change the O-ring in the battery compartment at the
same time you change the battery.
The Actiwatch battery is required for data collection, reading, and writing.
Actiwatch has a non-volatile memory, i.e., data stored are not lost after the
battery has run down. If you are attempting to read a device with a low battery,
the Ready LED will still light on the reader. It is recommended that you keep a
log of the battery changes for each Actiwatch.
The Actiwatch battery is a CR2025, 3-Volt, 220-mAmp-hour Lithium Manganese
cell. To properly install this battery, specific items may be required. These items
are included in the Battery Change Kit from Mini Mitter.
Typical Battery Replacement Kit
Description Quantity
O-ring 6
Battery, 3V lithium cell (CR2025) 6
Screwdriver, flat head 1
Screw, machine, 1.6 x 6 mm 24
Cotton swabs 12
Instructions 1 set
Additional materials that may be required:
Denatured alcohol
X-Acto
®
knife blade (flat tip) or similar sharp knife
1. Remove the band from the watch. Use the screwdriver supplied to loosen
(approximately five full turns) or remove the screws in the slots in the
battery cover of the Actiwatch.