User's Manual
1-18 Introduction and Setup
Note: The ActiReader must be functioning correctly and be connected to
the computer to complete the COM port selection. The Actiwatch must be
metal side up (Serial Number up) to successfully communicate with the
ActiReader.
4. Click Next to proceed to the Communications Port Test.
Select the COM port from the list provided by the Automatic Search Results
5. Verify that ActiReader is connected correctly using the 3-point checklist.
If correct, select the Next button. You can also use the Skip Test button, but
the connection between the computer and ActiReader will not be tested.
If using a white ActiwatchReader,clicktheappropriatebuttoninthewizardor
see Actiwatch Reader later in this section.