Installation guide

- introduce the new value
- the introduced value is checked whenever you change the current selection
for the "Parameters" or choose to sync with "Sync all parameters to the OpenUPS". If the
result of the check is correct, the resulting value is shown in the "Change log" field,
otherwise error message might be popped up and the parameters selector jumps back to
the wrong value.
- after You have done with all parameter setting press the "Sync all
parameters to the OpenUPS" button to send all values to the OpenUPS.
IMPORTANT: without this step the new values will be lost, nothing is sent to the
OpenUPS.
For users who need to setup more devices with the same OpenUPS settings, it is
recommended to use the next section of the "Settings screen": the save/load parameters.
The "All parameters: OpenUPS ===> File (settings.ini)" button loads a full
configuration from the OpenUPS and saves it to the settings.ini file. You can disconnect
the current OpenUPS from the USB and insert a new one, than press the "All parameters:
File ===> OpenUPS (settings.ini)" button to send the last saved configuration into the new
OpenUPS.
Every save/load/sync operation on the "Settings" screen affects the progress bar
and the status bar on the bottom of the screen (labelled with "State:"). In rare cases You
might get error here with "try again" message. This happens in case of one parameter byte
get's corrupted or timeout occurs during USB communication and/or OpenUPS flashing
operation. Please try again and contact our support team only if the device gives this error
4-5 times in a row.