User manual

MINGDA TECHNOLOGY CO.,LTD
Figure 3.1.2 Software machine set interface
Nozzle diameter：Generally 0.4mm。
Recover Speed：Can make the retraction of the Settings, select the default,
can also be adjusted according to actual effect.
Recover Length：Can make the retraction of the Settings, select the default,
can also be adjusted according to actual effect.
The first layer thickness：Generally set: 0.1-0.3mm，This is related to plate
and nozzle distance. Select the default 0.3 mm, also can adjust according to
the actual effect.
Model sinking：If it's small between first layer and platform interface , then
automatically adjust model sinking, select the default.
Double Extruding：select the default.
The idle speed: select the default, or adjusted according to actual effect.
the bottom of the print speed: select the default, or adjusted according to
actual effect.
The fill print speed：select the default, or adjusted according to actual effect.。
The minimum layer time: select the default。
Whether to open the fan: select the default ; Open.
2.1.3 Plugins Interface and Start/End-G-code interface
This two page interface don't need to change Especially for beginners.
Besides：
18