Installation Guide

Wi-Fi WASP Infrastructure Installation Guide
Installation Guide
Section 1 About this document
Rev: 1 2 / 28
© Minetec 2019
1.1 Document revision
Document information
Release Date
Document Version
Notes
1/10/2017
0.1
Initial draft
3/10/2017
0.2
22/05/2018
0.3
Updated for WIFI WASP hardware.
19/02/2019
1.0
GA1 aligned release.
1.2 Reference material
In addition to any Work Instructions that are specific to the site and the following documents support
and supplement the information in this document.
Document
Notes
Wi-Fi WASP™ Access Point Assembly Guide
Delivered with device
Wi-Fi WASP™ Bridge Assembly Guide
Delivered with device
Vehicle Hardware Installation Guidelines
As supplied by Minetec
ICT Cabinet Assembly Guide
TBC
Wi-Fi WASP™ Access Point Data Sheet
On request
Wi-Fi WASP™ Bridge Data Sheet
On request
MineOffice User Manual
As supplied by Minetec
Detailed Design
Site specific, as supplied by Minetec
1.3 Audience
Installation of hardware is a specialist task that is to be performed by trained and competent
personnel. It is essential that the technician installing the equipment has knowledge and experience
in the installation of general electronic and/or communications systems on mining equipment. In
some cases more than one technician may be required to install the kit.
The intended audience for this document includes, but is not limited to:
• Technically qualified and authorised people who will install Minetec hardware, and have
appropriate accreditations for installing cabling.
• Electricians experienced with ICT hardware installation.
• ICT Technicians.
Exclusions:
This document excludes firmware configuration. Refer to the relevant configuration manuals if
applicable.