Installation Guide

Wi-Fi WASP Infrastructure Installation Guide
Installation Guide
Section 1 About this document
Rev: 1 1 / 28
© Minetec 2019
1 ABOUT THIS DOCUMENT
This document describes the Minetec system infrastructure installation to be undertaken. Minetec
Wi-Fi WASP™ Bridges ('Bridges'), Wi-Fi WASP™ Access Points ('Access Points' or 'AP') and ICT Cabinet
will be fitted in pre-determined mine site locations to enable tracking/zoning of vehicles,
visualisation of vehicles and task management.
This document covers the physical mounting and electrical power connection of:
1) Wi-Fi WASP Bridges.
2) Wi-Fi WASP Access Points.
3) ICT Cabinet.
This document does not cover the network configuration of any of the above devices. Providing the
network design is available before delivery of devices, each device will be pre-configured at the
factory. On delivery to site, it would be prudent for the hardware installers to confirm the network
configuration of each device before installing it. If any further configuration or firmware updates are
required, it is much easier to perform this in the workshop or office where the MineOffice server is
located with a mesh gate or similar.
If site-specific Work Instructions (WI) or Standard Operating Procedures (SOP) exist for any of the
tasks described in this section, use those documents in preference to these guidelines.
The English version of this document takes precedence over any translated versions.
Site Work Instructions take precedence over these guidelines provided they:
• Are current and complete.
• Are approved by the Mine Operator.
• Are specific to site.
• Do not conflict with the safety instructions within these guidelines.
• Do not conflict with any manufacturer specifications.